Spotting a Chibanez Jem tutorial Part 1 - Jemsite
<back   Jemsite > Guitars and Gear > JEM and Universe Guitars
JEM and Universe Guitars For discussion of Ibanez JEM and Universe guitars only.
 
Reply
 
Thread Tools Display Modes
  #1  
Old 11-04-2010, 01:13 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Spotting a Chibanez Jem tutorial Part 1


Alright Jemsiters, I have just finished the Chibanez spotting guide. There are so many folks that get burned by these, and other that just want to know how to tell the difference. I have to break this guide into two parts to make sure I get all the photos in. Here's a picture guide to light the way...
All of the following pictures show the real Ibanez jem on the left, and the Chibanez on the right.
Here's a side-by-side comparison of the two:

Take a good look the pickguard alignment on the lower horn:

Notice the location of this pickguard screw:

On to the back...
The neck heel is a dead giveaway! The Chibanez heel is longer than the pocket:

Next, look at the output jack access cover. It's routed in the wrong direction:

Now, look at the neck screws. First, they're not usually recessed like a real Jem, and the placement is off:

Finally, look at the trem cover. The slots are too big, and the bottom, horizontal slot is too high up on the plate:
quote
  #2  
Old 11-04-2010, 01:16 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Here's part 2.
Now let's examine the headstock. While they're getting better, the Chibanez logos are still off. The Jem logo is still too low on the headstock:

Now look at the truss rod cover. These have also been getting more accurate, but they are still too short:

The Ibanez logo has gotten better too, but it's still not place properly:

Finally, look at the font weight of the Jem logo--the Chibanez is still too dark and heavy:

Now, here's the scariest part--usually the first dead giveaway on the fakes--the trem. While these are a massive improvement over the older LoTrs knock-offs, they still have the screw on trem arm, unlike the pop in arm on a real Jem:

What's the scary part? Talke a look at the newest Edge knock-off! It has the pop in arm:

Take a look at the writing by the fine tuners. The real Edge reads, "Licensed under Floyd Rose Patents." The good-looking fake reads, "Tremolo Licensed Under Patents."

Well, there you go Jemsiters. I hope this little guide helps a avoid a catastophe or two...
quote
  #3  
Old 11-04-2010, 01:21 AM
(a)
IbanezFreak777  is offline
 
Join Date: Mar 2006
Location: Melbourne, Australia
Posts: 4,163  -  iTrader: (11)
Reviews: 25

Re: Spotting a Chibanez Jem tutorial Part 1


Great guide... but you've just given a tip to the chibanez makers on how to improve their copies :P
quote
 
  #4  
Old 11-04-2010, 01:27 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by IbanezFreak777 View Post
Great guide... but you've just given a tip to the chibanez makers on how to improve their copies :P
I thought the same thing, but if they haven't got it right by now with the plethora of pics and specs on the Internet--they never will. Plus, there's the little issue of serial numbers--I'm currently creating a database of all known fake serial numbers for all to check legitimacy of their contemplated purchase
quote
  #5  
Old 11-04-2010, 01:29 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Also, if you look closely at the vine patterns side-by-side--the differences are obvious.
quote
  #6  
Old 11-04-2010, 01:51 AM
PaiLien  is offline
 
Join Date: Sep 2006
Location: Buffalo
Posts: 78  -  iTrader: (4)

Re: Spotting a Chibanez Jem tutorial Part 1


Holy ****, that's the first time I've ever actually seen a fake Lo-Pro tremolo......good call dude. Sneaky little ****ers are getting creative, lol.
quote
  #7  
Old 11-04-2010, 02:04 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by PaiLien View Post
Holy ****, that's the first time I've ever actually seen a fake Lo-Pro tremolo......good call dude. Sneaky little ****ers are getting creative, lol.
All of the newer ones have a Lo-Pro knock off, but this is the first one I've seen with the correct pop-in trem arm.
quote
  #8  
Old 11-04-2010, 02:08 AM
(a)
Rich  is online
Vendor
 
Join Date: Dec 2000
Location: South Jersey
Posts: 23,514  -  iTrader: (22)

Re: Spotting a Chibanez Jem tutorial Part 1


I haven't even seen one with this new trem.

Don't be mistaken for a second, they will keep trying to improve them to the point even I won't be able to tell from pictures.
quote
  #9  
Old 11-04-2010, 04:16 AM
NSR  is offline
 
Join Date: Aug 2009
Location: Tyne & Wear, UK
Posts: 238  -  iTrader: (3)

Re: Spotting a Chibanez Jem tutorial Part 1


I agree with what you're saying that with all the correct pictures and specifications available. However, I can envisage this guide being printed off, rolled up and and whacked across the head of the designers of the counterfeits in order to improve them..."not like that one, like this one". It was on this basis why I suggested a sticky in this area of the forum for dealing specifically with a fake JEM or Universe, rather than show the counterfeiters how they should be done.

While your heart is in the right place and this guide will be helpful to some, you have essentially created plans in a nutshell that can be used to improve upon the current counterfeits and I fear that this may ultimately do more harm than good.
quote
  #10  
Old 11-04-2010, 04:30 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by NSR View Post
I agree with what you're saying that with all the correct pictures and specifications available. However, I can envisage this guide being printed off, rolled up and and whacked across the head of the designers of the counterfeits in order to improve them..."not like that one, like this one". It was on this basis why I suggested a sticky in this area of the forum for dealing specifically with a fake JEM or Universe, rather than show the counterfeiters how they should be done.

While your heart is in the right place and this guide will be helpful to some, you have essentially created plans in a nutshell that can be used to improve upon the current counterfeits and I fear that this may ultimately do more harm than good.
I seriously doubt it. If those boneheads haven't figured it out yet through the vast info on the web and the many threads here dealing with these--this guide is not going to make a difference to them. The one thing that you guys are forgetting, and it's mentioned above--the serial numbers are the other tell-tale indicator.
quote
  #11  
Old 11-04-2010, 04:42 AM
NSR  is offline
 
Join Date: Aug 2009
Location: Tyne & Wear, UK
Posts: 238  -  iTrader: (3)

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by AlaskaBat View Post
I seriously doubt it. If those boneheads haven't figured it out yet through the vast info on the web and the many threads here dealing with these--this guide is not going to make a difference to them. The one thing that you guys are forgetting, and it's mentioned above--the serial numbers are the other tell-tale indicator.
I'll respond to that with a quote:
Quote:
Originally Posted by Rich View Post
Don't be mistaken for a second, they will keep trying to improve them to the point even I won't be able to tell from pictures.
quote
  #12  
Old 11-04-2010, 05:14 AM
theapprentice  is offline
 
Join Date: May 2008
Location: Philippines
Posts: 197  -  iTrader: (0)
Reviews: 23

Re: Spotting a Chibanez Jem tutorial Part 1


I find it hard to imagine how hard it is for these Chibanez makers to simply buy a stock JEM, reverse-engineer it, and then make plausible fakes based on it. I'm pretty sure they're spending real money for their manufacturing as well, so why not save some and invest on a good reference axe to replicate?

Last edited by theapprentice; 11-04-2010 at 10:24 PM..
quote
  #13  
Old 11-04-2010, 05:56 AM
jonnyboy mills  is offline
 
Join Date: May 2009
Location: Manchester UK
Posts: 693  -  iTrader: (0)
Reviews: 2

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by theapprentice View Post
I find it hard to imagine how hard it is for these Chibanez makers to simply buy a stock JEM, reverse-engineer it, and then make plausible fakes based on it. I'm pretty sure their spending real money for their manufacturing as well, so why not save some and invest on a good reference axe to replicate?
I was about to say the same thing.
quote
  #14  
Old 11-04-2010, 08:16 AM
sixx_ gunner  is offline
 
Join Date: Oct 2007
Location: Florida
Posts: 27  -  iTrader: (0)

Re: Spotting a Chibanez Jem tutorial Part 1


Awesome! Lots of good info.
Thanks for putting that together.
quote
  #15  
Old 11-04-2010, 11:20 AM
AlaskaBat  is offline
Banned
 
Join Date: Dec 2008
Location: Houston, TX
Posts: 9,291  -  iTrader: (18)
Reviews: 98

Re: Spotting a Chibanez Jem tutorial Part 1


Quote:
Originally Posted by jonnyboy mills View Post
I was about to say the same thing.
Not to mention the blueprints that are available online for free! These blueprints details a complete Jem right down to the last mm.
quote
Reply

Tags
chibanez , china , fake , jem


Thread Tools
Display Modes

Show/Hide Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Show/Hide Similar Threads
Thread Thread Starter Forum Replies Last Post
Swirling Is An Art (Tutorial) RG462 Tech: Setup, Repairs and Mods 81 04-30-2015 09:11 AM
Need Help Spotting A Fake... Gunner4Life Other Ibanez Guitars (including Premiums) 10 09-08-2009 11:31 PM
'80s Hair Tutorial?! SilverEra Off-topic / Miscellaneous 19 08-09-2009 06:38 AM
Spotting a fake catbert1963 JEM and Universe Guitars 8 12-27-2008 03:59 PM
swirl tutorial ? Babook JEM and Universe Guitars 334 06-27-2004 04:03 AM

Sitemap:1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29
All times are GMT -4. The time now is 03:42 PM.
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
(c) jemsite.com
Powered by