Pickguard for an RG421?

[EvoGiant]

I decided that i really wanna put a white pickguard on my RG421. where can i get a pickguard that will work? i dont wanna get a jem pickguard only to find out that it wont work....i checked the vendor on the main page that sells pickguards, but those are custom and a little pricey for me. (prices start at $75). anyway, could you guys point me in the right direction? its gonna have the typical 1 vol, 1 tone, 5-way switch and 2 HBs. suggestions?

i used the vrg page and made this.....i think it would look even more awesome in person...
help me do this...ha ha. thanks.

[wilch]

I have recently had a clear one made by ETguitars for my RG421. It fits perfectly, and is cut so the bridge area sits properly, unlike the stupid Jem fixed bridge model.

Fantastic workmanship, and service by Ernie too.

I just received it today and will be installing within the week when time permits. I'll post up photos too.

[wilch]

I just re-read your post. You don't want a custom one. Hmmm...

I don't think there are any available that aren't "custom". I too searched for one.

[EvoGiant]

well, i meant nothing fancy...like swirled or somethin like that. i found a couple on that auction site, but im a little leery..... how much did yours cost? (if ya dont mind)

[wilch]

Shoot him an email to find out how much he will charge. Mine was kind of a "prototype".

Clear too. But I'm sure he can do solid white, or black.

[EvoGiant]

check out this number for that auction site.... 360109900756
it looks like it will fit over top of the switch. looks like all i would have to do is remove the knobs, mount the pickups, and then screw it down. opinions?

[archtop]

Give Roger a from Jeannie Pickguard at the link below. I put one on my RG770 and it fit great. Plus at $42 you cant beat it.

http://home.comcast.net/~pickguards/