Tightning Bar on RG320FM

[Ozzdoc]

How the hell do you do it?

I thought it was in the spring cavity, beside the Trem block, and a allen key goes in it and you just spin it to tighten, which i have done, but it DOSENT tighten!

So what am i doing wrong? It's an EP3 btw...

[damo7v]

am going to assume that the edgeIII and the edge pro II are similar (based on what i remember of ones i've owned, they are).

there's an allen screw at the base of the bar holder. this is only to raise or lower the bar in relation to the bridge.

there should be one or two allen-head worm screws accessible from the rear of the bridge that provide tension against the bar. you'll need to tilt the bridge forward heavily to see these.

[Ozzdoc]

mm thanks man, good info, I'll try what you said, time to have some nice dive bombers!

EDIT: Thanks man, it worked...