is this possible?

[Homebake]

would it be possible to attach an rg2550z neck (edge zero, 43mm nut without string retainer bar) to an edge/lo pro routed body?

as far as i can see, the only issue would be making sure the bridge lines up with the nut?

[LonePhantom]

You've got to remember that the Prestige Wizard necks are slightly wider than the earlier Wizards. you would most probably have a little minor woodwork to do to get it to fit.

[Homebake]

wider in which part?

[eviltwin]

58mm at the 24th fret, which used to be 56mm.

[Homebake]

provided you managed to fit the 58mm neck to a body, what would happen if you attached an edge or a lo pro to the body? how would that work with string spacings?

[nickcoumbe]

Hmmmm,

As long as your nut is correct on the neck I don't think it is an issue. They do sell different width nuts but they work with the same trems. I think it would be fine. I am pretty sure that I have used different floyd types on different neck widths.

[eviltwin]

String spacing hasn't changed with the advent of the 58mm neck.

It's determined by trem spacing, which -IIRC- is similar on LoPro v EdgePro but is slightly different on EdgeZero, but not enough to make any difference.