Connecting my G-Major to my JSX Combo

[dave_irishman]

Hey Guys,

Just got my G-major Effects Processor this morning... But I'm still trying to figure our the best way to run it through the effects loop of the JSX Combo. How do you guys do it? What inputs/outputs (that go through the effects loop) do you use on the G-Major? And I cant seem to get an good settings for the send and return levels on the back of the amp.. At the moment I need to turn the amp master up a lot when the effects loop is engaged and when I turn the effects loop off there is a MASSIVE volume boost....

Any Ideas?

Any help here would be greatly appreciated!

Thanks

Dave
Ireland.

[reguv760]

It sounds like you need to configure the G-Major's input sensitivity. Under I/O setup, find "Input Range", if it's "Pro" and select Consumer. Readjust Input/Output volume knobs to noon.

Reg

[Dantesstudio]

Originally Posted by judasbane

It sounds like you need to configure the G-Major's input sensitivity. Under I/O setup, find "Input Range", if it's "Pro" and select Consumer. Readjust Input/Output volume knobs to noon.

Reg

That could be it, it also kinda sounds like you may have messed up the send return connections.
The return goes to the out and the send goes to the in. Just as a side not, what are you using as a foot controller?