Digitech xp100 PROBLEM!!!! please helP!

[chris state]

My xp100 is all messed up right now. When i turned the thing on today, it went into this wierd mode where the thing jsut says "ca" or "er" or a bunch of random letters. whenever i press any button, it jsut goes to a new set of letters. there is no signal either. what do i do?

thank. this is a bad first post, but ive been reading here for a long time.

thank you

[bduersch]

If you can't do a hard reset (I don't know how to do one on an XP100, but usually there's a way to reset it by holding down a button and turing it on--you may lose any patches/settings you've saved, though), it probably needs to be taken in to a shop. I had a GSP21 and a GSP2101 that flaked out. The GSP21 had to go into the shop, but I was able to bring the 2101 back to life with a full restore.

Good luck!
--Brent

[jem7pbk]

My old one did that once The Ca means calibrate I pushed the pedal all the way forward then all the way back and then taped the button and it went back to normal. Try that.

[chris state]

ok, im stuck in the user presets, and i have no idea what to do?

damn thing. *******
digitech.

[Cevincc]

Howdy. I'm having a similar problem. I'm doing the Factory reset, I get Er code. Not working. So here I am...maybe you can fix in the manual. If not hmmm to da repair shop. Factory Reset/Pedal Calibrate - To reset the User programs to their factory settings and calibrate the
expression pedal, press and hold the <BYPASS/(Hold)TUNER> foot switch and apply power to the unit.
Wait until the letters rS appear in the display and release the foot switch. The display will now show: Pd
and CA , indicating that you are in pedal calibrate mode Once Pb appears, rock the pedal back and
press the <BYPASS> foot switch. When PF appears, rock the pedal forward and press the <BYPASS> foot
switch. SA will next appear in the display to confirm the pedal is now calibrated.
S

[6fingers]

Originally Posted by Cevincc

Howdy. I'm having a similar problem. I'm doing the Factory reset, I get Er code. Not working. So here I am...maybe you can fix in the manual. If not hmmm to da repair shop. Factory Reset/Pedal Calibrate - To reset the User programs to their factory settings and calibrate the
expression pedal, press and hold the <BYPASS/(Hold)TUNER> foot switch and apply power to the unit.
Wait until the letters rS appear in the display and release the foot switch. The display will now show: Pd
and CA , indicating that you are in pedal calibrate mode Once Pb appears, rock the pedal back and
press the <BYPASS> foot switch. When PF appears, rock the pedal forward and press the <BYPASS> foot
switch. SA will next appear in the display to confirm the pedal is now calibrated.
S

Dude it's a thread from ........................2001!!!
Do you really think he's still waiting for a reply?
Another thread digger lol