MIDI help, anyone? - Making them all talk

[slug]

Hey, all--

Been a long time since I've been around and the forum layout has changed a bit. *It's nice. *Hope I'm putting this question in the right spot. *Here goes:

I just recently purchased an Alesis Quadraverb Plus. *A buddy gave me his old ART X-11 midicontroller. *Problem is, I received no manuals with either. *Stupid, I know. *Any information on how to get the channels matched up and speaking correctly would be greatly appreciated. *I figure there's at least one of you MIDI gurus out there, and I'd sure appreciate a hand here. *I haven't found much about this on the web, but maybe someone knows of a good site for advice.

Thanks a ton,

mg

[vwall]

I havent used either of those products before. I am actually not fond of either maker, however, before you spend alot *of time searching, maker sure that the ART controller is a FULL midi and not a dedicated midi. ART is super known for midi foot boards that will only operate their stuff, like the Digitech controll one is only for a few of their products.

If you know for sure that its a true midi board, you will need to map the midi to speak to each other. I cant tell you how as i dont know these products. a manual would be needed.
But for starters, map your alesis to control 1 and see if that works....

[luther]

my ART x-15 works with the MIDI capabilities of my Ensoniq DP/4. *I can't remember where I got the manual online, *but I did find it. *Email me if you want a copy of the x-15 instuctions.

Luther