Ibanez JEM Forum banner

Noise Supressor in Effects Loop

3K views 2 replies 3 participants last post by  surfdog777 
#1 ·
I have a Boss NS-2 and I am thinking that (when I get back as it is away getting repaired :roll:) I might try putting it in it's effects loop (that I currently do not use).

If I were to just put the pedal itself into an effects loop, how would I wire it up? Now this typically would be a very simple thing, however the NS-2 only suppresses the noise of pedals in its send / return loop.

So how would I wire the Send / Return loop of the amp to the Send / Return loop of the NS-2? I was thinking:

Amp Send > NS-2 Input > NS-2 Send > Patch Cable to NS-2 Return >NS-2 Output > Amp Return.

Yay? Nay?

Cheers.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top