Power Adaptor

[AleTheNervo]

Just a question:

I want to power a Boss-ds1, a behringer dd-100 and a Morley BH with a 300 mA power adaptor. Is it enough?

How many mA need the single units (Boss, Behringer and Morley)?

Thanks guys

[elcid]

It should say it somewhere on the pedal, otherwise try Boss's website

[Sabre]

I use one for a few effects and its 200Ma at 9v.

I think that would be OK, but check what it says on your pedals.

[AleTheNervo]

thanks man, but all i found was 4,6 mA for the boss, 9,1 mA for the Behringer and 12 mA for the Morley but it seemed too little to me...(someone said me the BH is 200 mA(!) but this seems pretty much altough so I wanted to know from someone expert)

[AleTheNervo]

So, noone else?

[surfdog777]

I use the 1-Spot to power 11 pedals (7 Boss, 2 morley, 1 Ibanez, 1 MXR) and it works just fine. Zero hiss, zero hum, zero problems.
They cost about $29 + another $10 for the daisy chain.

[carlos seo]

Check peak electrical current consumption for each pedal and sum that to get what you need. I'm pretty sure a 3.42W (9VDC/380mA) power source is enough for 3 pedals.