Recording a POD 2.0 into Protools MBOX

[Batchimp RG]

Has anyone got recommendations which is the best way of doing this?

My POD has got 2 output jacks...does that mean I have to use 2 input jacks on my Mbox or is there a way (without a mixer) that I can go directly from my POD to MBOX fuss-free.

[Batchimp RG]

Anyone?....it's a very quiet thread

[Rip]

im not too too familar with the mbox..but
no doubt it has line level inputs.

Just use the line outs on your pod, it'll be much cleaner that way.

Im not sure if the pod outs are -10db or +4db line level..
but just make sure you have the mbox set up to match.

its ALWAYS a good thing to keep the signal path as short as possible.
dont run through anything thats not needed.

[shredmaster]

this should be an easy fix. run the left out of the pod to the left (track 1 in) of the mbox. run the right out of the pod to the right (track 2 in) of the mbox.