Need a wiring diagram please

[DV8]

O.K. This is what my dream switching set-up would look like on my 1570, but I only have experiance replacing a few pickups in the stock configuration. So here goes:

Position 1(All the way towards neck): Neck Full humbucking
Position 2: Neck Split/Middle Single
Position 3(Middle):Neck and Bridge Full Humbucking
Position 4: Middle/Bridge Split
Position 5: Bridge Full Humbucking

As you can see the only real differance from stock is the middle position changed from the single coil only to both humbuckers. So how would I do this, with a jumper or something? I just miss the richness I could get from my old 320 I got rid of with both humbuckers on.

Thanks for any help,

Joel

[phantoms]

I think the easiest way would be to leave the stock setup, swap out the tone knob for a push/pull pot and then add a jumper from the front pickup's Red wire to the center terminal of the push/pull switch. Jumper the Rear pickup's Red wire over to the outside terminal of the push/pull switch. The guitar would work as normal when the push/pull was down, but combine the two humbuckers in position 1 or 5 when the push/pull is up.

[DV8]

Thanks for the idea phantoms, but I was looking for something that I can do with just some new wiring and not having to get a new pot. Any other wiring guru's have an idea?