Puckup leads too short! Need advice...

[Crazy_Guitar]

Hey folks!
I have a used DiMarzio 4-conductor humbucker neck pickup to be installed in a guitar. However, I noticed yesterday that its leads are too short!
What is the best way to "extend" the leads? Solder another 4-conductor cable?

All input welcome!

[nsabino]

Originally Posted by Crazy_Guitar

Hey folks!
I have a used DiMarzio 4-conductor humbucker neck pickup to be installed in a guitar. However, I noticed yesterday that its leads are too short!
What is the best way to "extend" the leads? Solder another 4-conductor cable?

All input welcome!

Hi, yeah just solder an extension to the existing wires and you're set, I've done this a few times and it works out fine.

Regards,
Nelson

[Crazy_Guitar]

Thanks!
Any tips to keep the job neat and clean?

[C.Thep]

Originally Posted by Crazy_Guitar

Thanks!
Any tips to keep the job neat and clean?

Heat-shrink tubing and patience.

[nsabino]

Originally Posted by C.Thep

Heat-shrink tubing and patience.

Thats the best way to go...

Regards,
Nelson