Wiring Crunch Lab + Liquifire + Lace Sensor Red HSH Setup on Ibanez RG270

[Nevy]

Hello Everybody,

For the first time, i'm going to enjoy a pick-up switch and I decided to do that on my good'ol Ibanez RG 270 !

The setup will be H/S/H with, as the thread stated :
-A Dimarzio Crunch Lab in the bridge position
- A Lace Sensor RED single Coil in the middle position
-A Dimarzio Liquifire in the neck position

I made a lot of research but I can't find the wiring diagram that matchs the setup I want.

I made a blank wiring diagram as follow


I found this on the internet regarding the dimarzios but i don't find it very helpfull as there is no place on the 5-selector to fit my Lace sensor



If Anybody would have the kindness to give me a hand on this I would be very grateful, im a total noob in regard of pickups and electronic

ps : Sorry for the wall of text in bad english xD

Cheers ! \m/

[Swirltop]

This is the one you want here:

http://www.dimarzio.com/sites/defaul...50-2HB1VV2.pdf

The green and white from the lace sensor go to ground on the back of the volume pot. The orange goes to the 2nd terminal in on the 5/way just like the single coil in the diagram. everything else stays the same.

This will give you neck, neck split/middle, middle, middle/bridge split, and bridge for your switching...

[Nevy]

wow thank you very much mate !

I was thinking of getting rid of the lace but with that diagram seems all good

Now solder time ! xD

Cheers

[Nevy]

here is the diagram updated if anybody needs it for further use

[Nevy]

I ve done the solder and it works great except that there is a mistake,

The red neck is going to the 3rd pine (not the 1st)
The red bridge is going to the 1st pine (not the 3rd)

[Swirltop]

All you really had to do is turn the switch around, but if you swapped the reds you also need to swap the black and whites from each humbucker... or put the reds back and turn the switch around

[Nevy]

ahah xD
I see i will then turn the switch and put the red back in place