- Question about Intonation, and Rich.
- Some shots of my finished 520 NM.
- Graduated fret technique for lower action. Anyone try this?
- LR BAGGS PIEZO PRE-MOD QUESTION
- Restringd my RG. Now problems with the bridge, its fu**d
- ooooooh fate you are a bihatch
- Half-Scalloped RG 570 QSTB
- Creaking neck and Tuning instability
- 2-Q's: 14-string bridge and gold plating
- best way to LOWER a fret?
- Knob problems....
- armholder-trouble (jem555)
- Ibanez RG inlay questions
- Jem7vwh wow or lfo like syndrome!
- UK / European based Luthier supplies
- Mandolin tuning help
- Jointer problems: unequal measurement from end to end
- question for swirlers
- Lo-TRS Mod
- Can I place a single coil in the neck position of an RG?
- how do the ibanez piezos sound?
- compound radius for fingerboard and frets?
- Customizing an RG-7 (ideas + pics are welcome)
- mid boost clapton strat
- Lo-Pro Maintenance
- Ibanez RG-3120 Setup Question (new to site)
- question about neck bow, and bending strings.
- Pics of Abalone tree of life on maple board anyone?
- EVO and RG750
- How to eliminate hum?
- content of Lo-pro edge...
- Wierd Lo-Pro Edge 7 problem... big problem!
- jem truss rod question?
- Reputable guitar tech Baltimore area?
- glue on JEM. HELP ME
- Callaham Guitars Vintage Strat Bridge Installed
- Intonation on my FP
- Edge Pro and Edge..
- locking nut making weird cracking noise
- Faded RW Fret Board
- Swirling truss rod cover + pickup switch knob...
- questions Id like answers to
- Nuts?
- DBK pickguard is wasted.....can a replacement be found??
- Cheapo frankenstrat
- RG550 Pickguard?? Different sizes ?!? WTF?
- setup question (frets sound dead)
- about jem neck
- 620x setup - need help
- For those among us who build guitars...
- [b]Gotoh/Wilkinson VS100 trem: your opinions[/b]
- Help to repair a "snapped" neck.
- Show me how to "Swirl" a paintjob.
- What kind of material cloth should wipe my guitar with?
- more questions (fretting about fret buzz)
- Is the LoPro Edge easily swappable with the Edge?
- refinishing my saber
- How to adjust Edge Pro II
- Any advice on how to route the slot for the stem of a vine?
- Chrome paint on Jem10 pick ups
- How do you make the fretboard feel slippery?
- Correct way to clean Maple fretboard...Can I get the skinny?
- Project: RG-IDOL
- Identify my Bridge please
- Found a tremelo cleaning tutorial...
- RG 7420 bridge
- Loose Truss Nut (REALLY need help here guys)
- 1's, 2's and 3's on the back of Lo-Pro saddles
- Tightening Tuners
- Custom paint job?
- Bridge on RG 3120 pulling up....again
- Why does tuning go sharp insted of flat?
- WHY CANT I FIND A LO-PRO IN POWDER COSMO!!?!?!?!
- Not to be redundant...
- Jem7v problem
- Getting a cheap strat, can i change the neck profile?!?
- Mesa 50/50 problems. Just tubes?
- eek, snapping strings like that was its job
- Where can I buy a LoPro Edge?
- What glue to use for graphic and fabric top guitar projects?
- Burrs on knife edge??
- Elementary restringing question (I hope)
- Jem7v floating Trem Tension
- Know where to get a 17" radius neck sanding block?
- Possible Way To Lock Floyd Rose Posts
- Any good Clear Paint for my Alumina pickguard???
- My new project: assembling a true super Strat (the Ibastrat)
- How do i fix this on my JEM?
- Finally done with my vine inlay
- Chrome vinyl film a viable finish?
- White pearloid scratch for jem 555 wh
- Looking for colored plastic inlay material
- 8-string parts???
- converting US preamp to take Aus power?
- Electronic problem
- Need help designing a body
- disconnect tonecontrol
- Lo-pro edge = Edge Pro
- Plan on making a RG style axe, some help need please guys
- Removing grease and dirt from fretboard with benzine?
- 550 teething problems!
- oops
- Setup problems with my DBK...good price for a quality setup?
- Anyone ever put a *large* vinyl car decal on their guitar?
- Universe Necks
- Edge Bar Washers
- RG550 Neck specs / dimensions
- Cleaning new Ibanez wrenches
- cutting an original neck to become an all access neck
- Trem guards on Edge, ala early JEM777 models
- Anyone tried out this guitar company?
- How about this swirl...
- Question about sealing my guitar body...
- Edge adjusting and tremolo springs
- Blue Jem is Now DPP Jem
- Guitar "feel"
- guitar/bass tech
- Need help,Eggle Carving/tone/vol controls
- What does it mean?
- Removing bad saddle screw?
- Trem posts lean toward neck??
- How? removing a stuck on scratchplate from an acoustic...
- Will I need a new setup if I sent my neck out somewhere?
- High E string keeps going flat
- tune up, lock down, tune up again?
- Help with Intonation
- Need help with custom project
- Adding a pickguard to a rearrouted guitar
- Pickguard Question...
- using raw cold-pressed linseed oil to finish the neck?
- Gold pickguard screws (sorry if this has been touched on..)
- Monkey grip: Does it affect sound/resonance of the body?
- knob rubbing on guitar body...
- What does refretting cost???
- 7DBK setup problems.
- Zero Point trem
- snapped trem bar
- Safe Proofing the plastic on Dimarzio Clip Lok Straps.
- somewhere to buy a replacement nut for an RG7620
- Stud set screw problem
- plz help got serious a problam with my tremolo :(
- Nut shim...Any material?
- feel?
- Two Questions about my guitar
- My tremolo is F**ked up!!!! help!
- S/S/S in RG?
- Resonances
- Repairing clean finish chips.
- Eek! RG neck problem - help!
- Wiring Emg 707's?
- refinish
- Green discoloration on mirrored guard?
- nervous about jem7vwh nut bolts
- Will an Edge Pro fit the Edge (not Lo-Pro) mounts...
- re-finishing
- Daft
- custom graphic finish
- question about trem
- Vicious humming humbucker!
- Intonation - help me out please
- rg2120x problem
- Nitro cellulose polishing?
- Swirl Color Ideas
- D string refuses to intonate
- Truss rods and the Ibanez manuals
- Fret leveling on a new neck
- Q:whats the green stuff on the back of my neck
- fret 24 low E out of tune
- Here's the plan
- Wiring a EMG without the tone-control...
- question from first time double locking trem user
- rich where did you learn all this?
- How to do a trans black finish
- What to use for clear coat
- Intonation Tool??
- Edge Trem and .10-.52 strings (yes...)
- Lo pro in cosmo powder...
- Done with my finishing/swirl project...
- Strat Setup Help!
- Floyd Rose
- Vicious Humming and Irritating Humbuckers!!!!
- G-Major and Behringer FCB1010 -- How the hell?
- Replacement options for Standard Strat Bridge
- 7 String Palmrest
- Good place to repair guitar in Seattle area
- Edge pro Trem arm making cracky noises!
- Pickguard Project in AutoCAD
- man am I lucky!
- Urgent attention for a drunk 7VWH!
- How can i clean my ebony fretboard?
- width of a 6 string vs that of a 7 string ibanez body
- Major tuning and Floyd Rose problems
- Pickup Replacement Ibanez S
- Strange noises in the neck when doing whammy dives
- Lo-TRS II for OriginalFloyd: Fender, Schaller or smth else?
- Floyd rose question
- Trs to Edge/LoPro
- curing time for polyurethane
- Does This Seem Practical?
- Volume and tone pot noises!
- Logos
- Switching Earvana nut for locking nut
- Old lo-pro edge still available?
- Ibanez tool kit
- Professional Setups
- Absolute grounding NIGHTMARE!!!
- getting a js-series guitar chromed
- tone knob
- in what type of store can i get lemon oil?
- need some help with a freting out ,buzzing note in a jem7vwh
- rewiring
- Wade Finch...read this
- The tone of different nuts-
- New Radius! BUT a small setup problem...
- lo pro
- necks
- can you help me chose strings??
- Wasn't someone working on a CNC program to make bodies?
- er.. necks - Take 2
- trem setup
- small (probably stupid) Baritone idea.
- 2.0 mm on 24 fret low E string is low action?
- full whammy dive - should the high E drop completely?
- Trem Bar Washers
- MMM1 bridge adjustment - manual anywhere?
- Another Textured finish on the way
- 10 gauge strings and trem angle...
- Why are bolts-ons so easy to whack outta tune?!?
- Building my first V body..
- trem questions
- supposed problem with EDGE tremolo
- AllParts blue knobs for a Jem77BFP
- foyld trems vs vintage style
- followed the guide, and the buzzing frets just wont go!
- Gauge of strings?
- Lowering tube amp output?
- LO TRS Trem II
- Strings fretting out when using trem
- Truss Rod adjustment on RG2020
- whats wrong with my edge pro?
- Choking at 24th fret
- Another Q on Veneer vs Photo Top vs other.
- Making My JEM10th a "Real Player"
- Blocking edge floyd!
- Jemsite's Tech Setup for RG ?
- what was the name of that site for repair tips and tricks
- problems with the floating bridge on a 2003 JEM7VWH
- Modding an RG!
- Jem Volume Pot
- Project Strat problems.