Jemsite - View Single Post - Jem90HAM Wiring -About to Go Nutty
View Single Post
post #1 of (permalink) Old 10-26-2020, 05:24 PM Thread Starter
txaggie929
 
Join Date: Oct 2020
Posts: 5
Jem90HAM Wiring -About to Go Nutty

Ok, need somebody smarter than me here. Acquired a JEM90HAM and somebody had botched the wiring.

I disassembled the entire electronics cavity and started over. I would up using the schematic I have attached. I have rechecked all my wiring at least 6 times now and resoldered all grounds. I used the existing VLX91 switch and existing pots.

The setup is: 1- neck, 2 -split neck & middle, 3 -both humbuckers, 4-middle and split bridge 5- bridge.

I get quite a bit of hum in every position except for position 3 (both humbucker together) and then it's almost dead silent.

This VLX switch I assume is original (22 years old)....could this be my culprit? If so, what switch should I get as a replacement?

Have no idea what to do besides order all new parts at this time.
Attached Files
File Type: pdf JEM7mod1.pdf (82.9 KB, 11 views)
txaggie929 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome