Ibanez JEM Forum banner

JS Edge pro to Original Edge

854 views 2 replies 3 participants last post by  sebastian 
#1 ·
Hi guys, anyone replaced an edge pro with the original edge?
My question, do they both have same measurements and fit in the Ibanez JS tremolo routing?
I appreciate your feedback.
Thanks
 
#3 ·
I have a body that I did this to.
The two bottom corners of the trem cavity just needed to be squared up a bit.
I just used a paint stir stick wrapped in sandpaper.
It took a little while but I didn't damage the paint on top of the body at all.
Then I took some fingernail paint and covered the raw wood up to match the body again.
It took about 30 minutes of sanding.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top