putting a duncan jb in rg1570?
would like to put a jb trembucker in , and swap out the v8, from 2004ish so it looks like id take the ibz red and switch that with the sd black on pole 1, then take ibz white on pole 6 switch that with sd red. then factory a ground from the ibz bridge pickup is soldered to a tab on the volume pot with the output jack on the same tab. can i just solder green and bare and this other wire to the pot or does it have to be on the tab? wires to the back of the volume pot? i wanna keep the exact same hsh 5 way setup. so the sd says to tape red and white together but that only applies if its a 2 pickup setup right? it seems i would use all but the white then tape that off. would that be right? thanks guys first post btw.