Ibanez JEM Forum banner

Fernandes sustainer / Signal issue

1K views 1 reply 2 participants last post by  shredman667 
#1 ·
Hi all,

I have just installed a new jack barrel to my ibanez 7vwh, i have a fernandes sustainer and a kill switch wired to the ground and signal points. My problem isn't major but i've noticed when i plug the jack in i have signal for a few seconds then fades out then back in again, once its done that every works ok and signal stays solid for the duration its plugged in.

It never did this before and i'm worried i've done something, soldered something incorrectly or its just something ill have to get used to?

Any ideas or knowledge shared is much appreciated.

Mike
 
#2 ·
hmmm not sure about that 1, sustainers are a blag to wire in. i maneged mine ok in the end but i had to call sim's custom shop to check i was doing it right. i have to say they were very helpfull, i spoke to martin and he took me through it step by step. maybe give them a call and see what they say. good luck :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top