Replacing Pickups on RG350DX
I'm trying to replace PU of my RG350DX with DiMarzio Series.
I desoldered the old INF Series, take care of draw down the diagram.
Reading the instruction I know that Red is the hot, Green/Bare is the ground, Black/White wires together and soldered to nowhere.
BRIDGE: - Super Distortion
red goes in 6th contact of the 5-way switch.
black/white goes in 1st contact
NECK: Super 2
red goes in 8th contact of the 5-way switch.
black/white goes in 3rd contact
red goes in 2nd contact of the 5-way switch.
With amp on I can see that the only positions that works well are the 1st (only Bridge PU) and the 5th (only Neck PU), so the 2 - 3(only Middle) - 4 are dead.
Where I've wrong with the solder?
Do you have any suggestions to help me.
Thousand thanks guys.
Last edited by zakarum; 05-06-2012 at 01:50 PM.