Jemsite - Reply to Topic
All Other Guitars (including Prestige) Discussion about other Ibanez Guitars not covered in the above topics. Includes J-Custom, USA-Custom, Prestige subforum.

Thread: A few questions about a NGD RG470 Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Jemsite forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address

IMPORTANT: You will be required to activate your account so please ensure that your email address is correct.

If you do not receive your activation check your spam folder before using the CONTACT US form (at the bottom right of each page).

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
09-01-2014 09:13 PM
Re: A few questions about a NGD RG470

Just dropped them a line on their facebook page. We'll see what they say.

Any suggestions for either the single coil pup being paired with the LF/CL, or for a replacement trem?
09-01-2014 08:29 PM
Re: A few questions about a NGD RG470

Im afraid I can't tell you much about that, but there seems to be some forums that mention this company as making onboard preamps. They don't show anything current at the site, but I would drop them an email anyway.
09-01-2014 06:33 PM
Re: A few questions about a NGD RG470

My apologies. Didn't think about that! Here are two of the chip. The soldering job and tape is a mess.

The back side of the circuit says "Copyright 1991, Made in the USA". I'm not sure about the STARR PA-1 or chip designation, but figure some of you all might be.

09-01-2014 04:54 PM
Re: A few questions about a NGD RG470

Your not giving us much to go on, You would probably need to look at the little circuit board and see if there is any info printed on it. Maybe take a pic of that for us to look at.
09-01-2014 04:07 PM
Re: A few questions about a NGD RG470

So, nobody here is, at the very least, able to identify the boost mod?
08-31-2014 07:00 PM
A few questions about a NGD RG470

Hey, all. I'd been thinking about picking up an inexpensive backup guitar for my RG920QMZ before I pick up a second solid axe next spring. I came across this Korean made 470 at a local GC. They were selling it for $300, and while that may be a little high for the make, it came with a nice hardshell Ibanez case, which I've been needing, so that offset the price by about 130. The neck is really, really well made. It plays just a little more smoothly than neck on my 920, which up until now has been one of my favorite necks.

Here are the Qs -

1) Check out the tone knob in the horizontal photo. It's split and applies some sort of a boost. Not sure if it's a mid boost, or just a straight ahead input gain, but at any rate, it makes the signal hotter, and basically serves the same purpose as my Suhr Koko or TS808 for leads or hot rhythms. Can anyone identify it based on design, and tell me what exactly it is? There is a circuit board packed into the body cavity, which is active, as it's hooked up to a 9V underneath the cavity plate.

2) The pickups (stock INF1/S1/2) are on the warm and wooly side of things, which makes for a nice contrast to the brightness and clarity of the BKPs in my 920. That being said, their warmth is offset by their father flat tonal variance. You can't tell a great diff between the neck and bridge pup, and almost no diff when the single coil is engaged with either. I'm thinking of putting the Liquifire/Crunchlab combo I pulled from my 920 into the 470, but have no idea of what would be a good single coil replacement. Should I get a Dimarzio set built as a HSH, like the EVOs or Blaze pups?

3) I've read lots of complaints about the Lo-TRS II. I've not had any issues with tuning stability since I properly set the action, lubed up the components, and set the locking nuts in their proper orientation (these are actually scooped, and if you place them in sideways, as these were, the strings slip right up inside the concave cavity), but I imagine that I'll eventually need to swap it out as things wear. I've read that an OFR is a solid trem to drop in its place - any other suggestions.

Fun little guitar, and considering the boost mod and hardshell case, not a bad purchase for the price. I really like that electric blue, btw, as a contrast to the quilted orange maple top on the 920.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome