Jem90HAM Wiring -About to Go Nutty
Ok, need somebody smarter than me here. Acquired a JEM90HAM and somebody had botched the wiring.
I disassembled the entire electronics cavity and started over. I would up using the schematic I have attached. I have rechecked all my wiring at least 6 times now and resoldered all grounds. I used the existing VLX91 switch and existing pots.
The setup is: 1- neck, 2 -split neck & middle, 3 -both humbuckers, 4-middle and split bridge 5- bridge.
I get quite a bit of hum in every position except for position 3 (both humbucker together) and then it's almost dead silent.
This VLX switch I assume is original (22 years old)....could this be my culprit? If so, what switch should I get as a replacement?
Have no idea what to do besides order all new parts at this time.
|All times are GMT -4. The time now is 05:28 AM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.