Ibanez JEM Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 500 Results
  1. Tech: Setup, Repairs and Mods
    Hello all, I am interested in replacing the lo-pro edge in my JEM7V SBL with an original edge so I can use a Tone Vise pitch shifter, and I had a few questions. I know the 2010 and after Edges have several small but notable differences from the 2002 and earlier Edges. Is there any reason for me...
  2. Ibanez JEM, UV, JS & Other Signature Models
    Hi! I have a Jem 70V (the seafoam green one). Does the Ibanez edge on it have locking studs in the bridge post? I'm assuming so as I tried to adjust the height but the posts don't move at all. I didn't put much pressure on the Allen key, and the bridge didn't make any noise. Could I have caused...
  3. Tech: Setup, Repairs and Mods
    Hey all, I've been sick of wearing the finishes on my Power Cosmo edge bridges and pickup rings despite wiping it all down after playing where possible (I think I've been through 8-10 sets of PC pickup rings for my RG570 over the years), and with a recent arrival of a RG5230L which has the Low...
  4. Tech: Setup, Repairs and Mods
    Hi everyone, My guitar is 20 years old and during all these years it has been used quite a lot. It's time to change the bridge because it has problems with keeping the tune after using a whammy bar. Knives were sharpened but there are still few more parts to change and they're not easily...
  5. Tech: Setup, Repairs and Mods
    Hi! I been trying to get my tremolo parallel to the guitar body, but it seems impossible. I have pulled the sprind adjustment knob as far as possible. What else can I do?
  6. Classified Ads: Guitars and Gear
    Hey Jemsite! Looking for a MIJ Ibanez with an Edge / FR bridge and mahogany body. And I'm sure I am not alone on this quest!
  7. Tech: Setup, Repairs and Mods
    Does all saddle should to has the same height at a Edge Trem or they has its own? I just disassembled it and didn't put attention in to the order of them. It seems that B and G strings are lowered. Thank you in advance guys.
  8. Tech: Setup, Repairs and Mods
    I decided to change the broken stud. and it seems like the previous owner actually glued it to the wood and there is no stud inserter. What are my options? how to remove this stud if it's glued and then put inserter + new stud. Thank you guys for your advice. Regards, A
  9. Tech: Setup, Repairs and Mods
    I have an RG570 body from Japan but no trem on it. Can I install a floyd instead? Is there another edge model that would fit it that's just as good as the original edge trem? cheers
  10. Tech: Setup, Repairs and Mods
    Can anyone recommend a guitar tech who knows their way around Edge tremolo?
  11. Classified Ads: Guitars and Gear
    i have an original backstop from ibanez. it is branded with the ibanez name on the back and has the textured top finish. it has never been installed and is new. looking to get 200.00 shipped to your door in the Cont USA. will have to figure international shipping if need be but will be extra. i...
  12. Classified Ads: Guitars and Gear
    Took me years to acquire these boys but I finally decided they need to be played and go to a good home. Both guitars are in good condition aside from few nicks in the body from putting it in guitar stand. Both necks are blemish, crack, damage free. Both are setup with low action, straight neck...
  13. Tech: Setup, Repairs and Mods
    I recently got a RG370AHMZ in Silver Wave Black. (Which is a very sexy guitar by the way.) I love it, but my only two problems are; 1. I can't lower the middle pickup very far, which both causes it to get in the way and reduces the sound options. 2. When palm muting, I end up pushing the edge...
  14. Tech: Setup, Repairs and Mods
    Hello everyone one, I want some help to set my guitar just right, And please do not tell me to take my guitar to a tech because there's no guitar techs where I live, not even in a 3000 km radius. So the thing is that I recently felt that my Lefty Ibanez Prestige RG655 plays a little bit...
  15. Classified Ads: Guitars and Gear
    My beautiful RG550 in Desert Sun Yellow from 1987 Made in Japan! Not the Genesis version - this is the real deal from the late eighties. This guitar has beautiful black hardware: Gotoh Tuners, Original EDGE Tremolo and Trem Arm. The pickups have been upgraded to the Blue Dimarzio Liquifire /...
  16. Ibanez JEM, UV, JS & Other Signature Models
    HI all, I just received a new Carbon trem arm from Rich and learned the bushings are bigger now on the new trem arms. It is for my JS2400, but is tight fitting almost can't get the arm in. It ried the arm from my JS2450 and it fits fine. Also the new trem arm is tight on my 2450. Any...
  17. Ibanez JEM, UV, JS & Other Signature Models
    Someone FINALLY did it, an updated arm holder for Edge & Lo-Pro Edge (Edge Pro too!) The company behind Luminlay just recently released a new product, called the "MAGIK-ARM" This is something I've been waiting for, literally for years. RED BISHOP High quality original guitar and bass parts...
  18. Tech: Setup, Repairs and Mods
    Hey guys, I was wondering if anyone could give me tips on restringing my Ibanez RGR652AHB that has an Edge trem bridge. I have successfully done so in the past, but it was always a painful, trial and error process. I'm pretty busy with school right now and so the last thing I want is to go down...
  19. All Other Guitars (including Prestige)
    I just scored a J Custom RG20126 SRU. I will take pics this weekend. Can I swap out the fine tuners and trem posts from the Edge Zero with the tuners and posts from an original Edge?
  20. Classified Ads: Ibanez JEM/UV Guitars
    Hi! I am looking for a Sea Foam Green Premium Jem in the EU. I am located in Madrid, Spain. As long as there is no structural damage, I don't mind it having dings, scratches, etc. since I may be refinishing it. Please send me your offers, if any.
1-20 of 500 Results