Ibanez JEM Forum banner

input jack

  1. Pickups & wiring
    I have an acoustic guitar Yamaha FS100C, I am planning to convert it into semi acoustic with a fishman preamp. Why i want to do this is to connect it to an output i.e. to this speaker...
  2. Tech: Setup, Repairs and Mods
    Hi there guys, pretty much as title says, I need to take off the input (barrel) jack on a RG guitar, but the old one seems like it is stuck, tried with some pliers from the end, where the lugs are, but the thing doesn't move, any idea? advices? tricks? Thanks! Arturo
  3. All Other Guitars (including Prestige)
    I have an RG1570 and I've always noticed the input jack to be a little tight. I didn't think too much about it until today when I noticed that it was tight to the point that it was scraping the gold coat of paint off of the side of the cable head. I've read on a couple other forums that Ibanez...
  4. Tech: Setup, Repairs and Mods
    I opened up a guitar that just arrived to rewire its tone pot as someone had mixed the wires up. Then I saw that someone had replaced the output jack as well. With a 1/4 inch to 1/8 inch adapter. The bottom one is the one from the guitar if you couldn't guess. Its rubber wasn't ripped up until I...
  5. Tech: Setup, Repairs and Mods
    I have a mid 90s rg and i want to move the input jack so its more like a jem js or pgm guitar. can i do that?
  6. Classified Ads: Guitars and Gear
    Hey everybody, Yup, I'm done looking at this stuff just sit around. O.B.O. on everything. I just need it all gone. Group shot: Close ups: Prices: 1. Rosewood fretboard from an Epiphone acoustic - $15 2. New 8ft guitar cable - $5 3. New 8ft guitar cable - $5 4. Backplate (fits most...
  7. Tech: Setup, Repairs and Mods
    i noticed today the input jack on my prestige RG seemed kinda looser than before. also, when it's plugged into an amp if you touch the lead a bit (eg. wobble it slightly, push it around) the sound cuts out. i've had 3 performances in the last 3 days and i'm wondering if i might have stepped on...
Top