Search Results for ‘installation’

If given a choice, would you prefer to buy a guitar with a sustainer already installed like the Banshee Elite or preferably to install a sustainer yourself? Which would you prefer?

So next week I'm ordering new pickups for my RG7321, and liquifire for the neck, and a d-activator for the bridge. After much research I finally decided that these are the pickups for me. What I need help with is doing through the actual installation of them, so If any of you guys can point me...

I just bought the Crunch Lab for my RG1570's bridge position. A little information is required. The previous V8 pickup has a pair of foams under it which the Crunch Lab do not have. Why do I need those foams under pickups? To lift the pickups upwards? Should I rip off those foams from the V8 and...

I recently bought a Jackson Kelly, and i switched out the Jackson CVR2 passive bridge pickup out for a Seymour Duncan SH8 Invader pickup The pickup is mounted in place and almost ready, but i still need to solder the wires in the right places. i do know that i have to solder the Red wire and...

So a friend of mine brought his Prestige over tonight, that he had the Evolution Bridge and Neck pickups put in at a Guitar Center a few weeks back. He was not crazy about them, and was debating on changing them out. So I told him I had set of Breed's that we could throw in and see what he...

I have a Godin SD with HSS and the humbucker has 4 mounting screws going into the pickup, two on each side, (which the one isntalled has the matching four holes). I am trying to mount my new seymour duncan dimebucker pickup but it only has 2 holes, one on each side, that are centered so it does...

I seem to have some major scratching sounds when I turn the volume knob. Ideas? Is it the possible grounding mess on the back of the pot perhaps? Should I just try re soldering it? There are like 9 wires that need to go on that little spot on the back of the pot. Does it matter how they are put...

Hi, I am in trouble. I have an Ibanez RG Prestige 2550EGK with DiMarzio/IBZ pickups. I just bought an AirNorton and a DSonic to replace the 2 original H but I want to keep the IBZ middle S since I don't use it too much. So I soldered the 2 new H wires exactly where the originals were soldered...