Ibanez JEM Forum banner

issue

  1. Get verified by [Post New Thread] to participate
    I've searched high and low and even tried contacting Ibanez support and still no luck. My Jem Jr tremolo arm used to stay tight and not swing but now it's loose and there is a bit of give when you try to use it. It's not snug anymore even though it's screwed on tight. Here's a pic...
  2. Tech: Setup, Repairs and Mods
    Hi guys, I've acquired a 2002 issue DT-420 Destroyer. The wiring, pots and capacitors are FUBAR because some kid messed around with them before I got the guitar. I'm going to try to replace them if I can. I was hoping one of you guys might be familiar with what components are used in the...
  3. Forum Announcements and Member Help
    no link allowed (you must have 10 posts). so I wanted to share the page I was looking at, so the admin would know what I am talking about but since I am not allowed to link anything, I guess my question will never be understood and the answers will not be on the right understanding.. I am...
  4. Forum Announcements and Member Help
    Hey guys I bought this used Ibanez RG 1570 Prestige, and I was pretty excited because it has the edge pro trem and decent pickups it's made in Japan and overall its seemed to be a pretty good guitar. But It won't stay in tune at all. I've spend 100$ on professional adjustment, the bridge is...
  5. Tech: Setup, Repairs and Mods
    Hello! ----------- What I use: ----------- 1. Ibanez RG770 2. Edge Lo Pro; Blocked with the wooden blocks; 3. Ibanez Locking Nut, screwed from the bottom; 4. SIT strings 10-46 (FR) and standart E tuning; 5. I play with a quite hard attack. Strings are fully stretched, saddle lock down bolts...
  6. Gear, Equipment, Recording & Off Topic
    (FIXED)Problem with my Bugera V5 I'm pretty sure this is just an issue with the tubes, but I'm no expert so I'd like to get some advice. I've had the amp for 2-3 weeks now and ever since I got it there was this glassy rattling noise when I'd play. It wasn't a big deal but as time went on it got...
  7. Pickups & wiring
    Hi, guys! I have installed a Fernandes 401 in my RG 550 and it seem to work as it should, BUT.... when I adjust the FGC pot to adjust the output of the sustainer driver in the neck position its the output of the EVO 2 in the bridge that is affected. Is this right?? I thought that the FGC pot was...
  8. Tech: Setup, Repairs and Mods
    ill skip right to the chase, when i roll back the tone knob, i lose 90% of my distortion and output. ALL WIRES ARE STILL ATTACHED!! its on my rg7620 with stock everything. happens on ALL amps. its obviously just the guitars problem but i figured it would be worth mentioning probably also worth...
  9. Tech: Setup, Repairs and Mods
    Hey, I went to re-string my RG2550Z tonight, and i came across a problem, i can't get the actual string off the trem, i am using the allen key and it just doesn't seem to loosen what-so-ever, no matter how hard i try, never had this problem on another floyd rose/floating trem before. PLEASE...
Top