Ibanez JEM Forum banner
knife edge
1-9 of 9 Results
  1. All Other Guitars (including Prestige)
    I took my Ibanez RG652AHM with Edge Tremolo to my tech today, and he adjusted the truss rod and I told him i was having trouble with returning back to tune after using the bar. It's tuned to E standard with 10-46 gauge strings. He adjusted the bridge for me, which before I took to him, had the...
  2. Comments to Ibanez
    Why can't they go back to selling these? Now when I screw up my knife edges I have to take a file to them and risk screwing them up even more, or I have to buy a new trem or used trem in it's entirety in order to get a replaceable set. How hard is it to send 50 pairs of knife edges to the...
  3. Tech: Setup, Repairs and Mods
    will it be ok if i use contact cleaners to lubricate the knife edge of the edge pro ? or can contact cleaners be used for lubricating knife edges ??
  4. Tech: Setup, Repairs and Mods
    I have a 2002 RG1570 (edge pro bridge). I can adjust my action up and down to a certain point. But when it gets low enough, the pivot stud (closest to the thinnest strings) goes down without the bridge. The knife edge is rounded on this side, and the same pivot stud is kinda stripped in the...
  5. Tech: Setup, Repairs and Mods
    Hello, My RG1570 has some intionation problems. It's bought in 2005 and I'm the second user. I'm going to replace the spring soon, but I also think the tremolo's (Edge Pro)knife edges have worn out. And as I don't live in the US, I find it hard to find any knife edges (tried googling around, but...
  6. Ibanez JEM, UV, JS & Other Signature Models
    Ok i know i've seen this posted before here, but I can not find where exactly. So my problem is when i depress the bridge and then release, it will return slightly lower than zero-point. And when I bend up on the bridge it will return slightly above zero-point... this pisses me off soo much...
  7. Tech: Setup, Repairs and Mods
    Sorry I'm a total noob here, but I have recently had a problem with my 2002 RGT42. It didn't used to be like this, but now when I dive or pull up on the LO-TRS II it will rest either too flat if I dive or too sharp if I pull up. I did some reading online and I believe the knife edges have...
  8. Tech: Setup, Repairs and Mods
    so i've had this old silver rg570 fixed up a bit. i had to get the stud insert holes fixed up since the stud inserts were wobbling and were not 90 degrees to the guitar.. tech at local music store fixed it up. i don't know exactly what he did, but they're not moving (although they're still not...
  9. Ibanez JEM, UV, JS & Other Signature Models
    My brand new JEM7V WH needs a new bridge!! Please help! I bought my JEM7V WH in November 2007 - but read on. After I regulated the height of the bridge and played for a very short while I had to put it back in the case until today - I was finishing my studies and had absolutely no time to play...
1-9 of 9 Results
Top