otax

Would an Oak Grigsby superswitch work as a direct drop in replacement for the Otax 5 way switch (the guitar in question is HH, RGT220)? Also, what's the correct size for volume and tone pots - CTS audio log 500k, 6.35 mm diameter / 9,52 mm thread length? Like these for example?

Body - players condition with edge dings all around and a repaired part on top by the forearm. Comes with back plates but no other hardware. Yes it has character but you can use it as is. No need to buy a raw body and then spend time finishing it up. Always buy a body with character unless...

VLX 5 way switch by Otax Switch is in good condition and works great. These are somewhat hard to find from what I understand. I'l include a switch tip as well, and I might have 2 screws. http://img197.imageshack.us/img197/3563/ibpartz6.jpg http://img146.imageshack.us/img146/8443/ibpartz7.jpg...

Hey guys, so I have a surplus of guitars and parts that I need to move. Feel free to message me with any questions you may have. I would prefer you to email ([email protected]) since my inbox fills up here pretty fast. No shipping outside of the US on these. Ibanez RT150 (MIJ) This beauty is...

If you're reading this you know what VLX91 switch is capable of. It was installed in one of my guitars a couple years ago but I don't need it anymore. Give me a shout if you have any questions.

A few years back , I got a wiring scheme from Scott Of Actual Time that was for a H-H configuration and the Otax 5 way switch. His scheme was similar to the stock Ibanez switching but also gave you two more combinations for getting the outer coils working together without defeating the stock...

Trying to wire an RG565 with two (stock?) four-wire pickups and a VLX91 switch. The closest setup to what I want looks like the schematic for the RGT3020 on the Ibanez site. However, wired exactly like that, the first switch position (bridge) sounds way too weak and the fifth (neck) position is...

Hey Everybody. I have an Ibanez RG 370 DX 3 with the stock 5 way switch with HSH configuration. I have an Air Norton for the neck position and a D-Sonic for the bridge position. I am going to disconnect the single coil. I want the following HH configuration: Neck Inside Bridge-Inside Neck Both...