Ibanez JEM Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Pickups & wiring
    Hi, I'd want to replace stock inf 3 4 and single coil infs3 of my rg350dx eith inf1 inf2 and infs1. But I have a problem. Stock inf have 3 cables red, white and black for humbuckers and black and white single coil. My inf 1 and 2 have 4 cables (black blue white and ground inf1) (black red white...
  2. Pickups & wiring
    Im trying to figure out how to wire this cab up without frying my amp. My cab is a 4x12 with a stereo/mono switch and its driving me nuts. There are 4 wires inside 1 set for stereo and one set for mono. Should I be using all 4 wires, 2 wires or mix match? We started out using the + and...
  3. Pickups & wiring
    Hello ya’ll, does anyone have a wiring diagram or instructions for the following configuration: Ibanez S670PB, Dimarzio Air Norton in the neck factory single coil in middle, Dimarzio Tone Zone at the bridge. 5 way Megaswitch E and Dimarzio EP1201 volume and tone pots. Also what are the best...
  4. Get verified by [Post New Thread] to participate
    Hello ya’ll, does anyone have a wiring diagram for the following configuration: Ibanez S670PB, Dimarzio Air Norton in the neck factory single coil in middle Dimarzio Tone Zone at the bridge. 5 way Megaswitch E and Dimarzio EP1201 volume and tone pots. Also what are the best makes of capacitor...
  5. Pickups & wiring
    hey guys, i got a bass that has older emg hz pickups that have only a braided wire with a white signal wire. they were part of an active eq circuit that went out so i junked the circuit board and now i want to wire the two pickups to two volume pots, no tones or switches. can anyone tell me how...
  6. Get verified by [Post New Thread] to participate
    I recently registered on this site as I found it very useful for an Ibanez owner (and not only for them). Currently, I own an Ibanez RG4EXFM1 and I would like to replace the INF3 & INF4 pick-ups with DiMarzio Evolution (bridge & neck). I will keep the INFS3 (middle position, single coil pick-up)...
  7. Pickups & wiring
    Now it's been forever since I've looked for one (I have memorized the ones I use most) but didn't we used to have a sticky with most of the diagrams on it? I had a friend I was trying to explain something over the phone to, and decided I would just send him a link, but I be damned if I can find it.
1-7 of 7 Results
Top