Ibanez JEM Forum banner

Can'y get low action from the 12th fret down

2404 Views 8 Replies 5 Participants Last post by  walterh
Can't get low action from the 12th fret down

Hey guys, I have a question. I recently bought a 2003 Jackson DX10FS from a pawn shop, and I'm trying to get the action to my liking. I have eyeballed the neck relief, and I have a very small gap at the 7th fret where you are supposed to check it. (Probably a gap the size of a thin pick or less. Anyway, I have lowered the licensed floyd rose down as far as it will go, and the action at the 12 fret is .50mm. I can't seem to figure out what else to do? I did change the 9's and went to 10's. Would that have an effect? I don't see how adding more relief will help my problem. Any suggestions????
1 - 1 of 9 Posts
.5mm at the 12th fret is ridiculously low. My PGM was setup on a plek, plays like butter, and is 1.3mm at the 12th.

Do you mean 5mm?
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.