Ibanez JEM Forum banner
1 - 5 of 12 Posts

· Registered
Joined
·
5 Posts
Good day mate. I’ve been researching a lot regarding the correct wiring diagram for the JPM. And the dimarzio site doesn’t help at all. It gives me Neck(with sound) Middle (no sound) Bridge (with sound) so for sure something is wrong. I bought the exact 3 way switch from Ibanez which is the 3SW1JPM3T. Would it be possible if you can email it to me please. would really appreciate the help.
 

· Registered
Joined
·
5 Posts
Just buy my MSM100 ;) instant JPM100 switching/layout, the only difference is it's got a TZ in the bridge :D Seriously though, thanks for contributing to the community, it really means a lot, as there is very little out there, as far as wiring diagrams for this sort of thing.
haha :) would love to get one MSM100 pretty soon. But I just got the JPM and I wanted to replace the 3 way switch with the correct to spec ibanez switch, as the one that's installed here by the previous owner is a different 3 way and more on a les paul type 3 way. 😀 I tried hooking it up based on the Dimarzio Website but still no joy, so I figured there must be some mistakes on my wiring. Might as well ask here to see if there's a correct way to solder the wires. I even researched the site but same problem as mine no sound on the center/middle position.
 

· Registered
Joined
·
5 Posts
Wow, I always thought the DiMarzio 3 way was the correct one :( I used to have a few JPM100's back in the day, but they were all original so I never had to bother with learning the wiring. I could always snap a picture of the inside of my MSM100 as the wiring on it IS identical and should use a switch that is contemporary. Lmk if you need that
Yeah, I thought so too that what they use is the EP111 but turns out the correct spec parts for the 3 way is a 4DPT ibanez 3SW1JPM3T. Yes please, if you can send me a snap photo of it, then it would totally be a big help 😀 Really appreciate the help! Thanks a lot
 
1 - 5 of 12 Posts
Top