I think the neck angle of my RG421 is too high, which is causing my headstock to be at a higher level than my body. You can see in the attached photos the difference in width between the neck and the body as you look towards the left.
http://bit.ly/2kjBf4k
http://bit.ly/2jQj45u
I took the neck off, but there were no shims. There was a lot of dust though, that I shook and blew off.
http://bit.ly/2joW22t
http://bit.ly/2jQixAr
What can I do now to lower neck angle? Should I try tightening the screws as much as possible? I have not reattached the neck yet. Could someone also give me instructions to do that without any equipment?
http://bit.ly/2kjBf4k
http://bit.ly/2jQj45u
I took the neck off, but there were no shims. There was a lot of dust though, that I shook and blew off.
http://bit.ly/2joW22t
http://bit.ly/2jQixAr
What can I do now to lower neck angle? Should I try tightening the screws as much as possible? I have not reattached the neck yet. Could someone also give me instructions to do that without any equipment?