Ibanez JEM Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hey all,

Just wondering if anyone's ever had this happen before - I followed Rich's instructions on tightening the trem arm holder http://https://www.ibanezrules.com/tech/setup/loose_holder.htmon my Edge Lo-Pro and the barrel just snapped right off in the middle of the thread where the nut sits against the trem base plate. Guess I'm going to have to get a new one now somehow, which is insanely pricey, being in South Africa and all.

I've been looking at these Red Bishop Magik-Arm replacements: https://www.ebay.com/itm/202858518406
Anyone had extensive experience with these? Or am I better off ordering an OEM one?

Any help or advice would be greatly appreciated.
 

·
Registered
Joined
·
6 Posts
Hey all,

Just wondering if anyone's ever had this happen before - I followed Rich's instructions on tightening the trem arm holder on my Edge Lo-Pro and the barrel pakistani rentacar hostel dubai just snapped right off in the middle of the thread where the nut sits against the trem base plate. Guess I'm going to have to get a new one now somehow, which is insanely pricey, being in South Africa and all.

I've been looking at these Red Bishop Magik-Arm replacements:
Anyone had extensive experience with these? Or am I better off ordering an OEM one?

Any help or advice would be greatly appreciated.
Hello it is up to you, make your own decision, because every person has his own experience with any thing used by a person.
 
1 - 3 of 3 Posts
Top