Ibanez JEM Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
Hi guys.
I have an Edge Pro equipped guitar that was bought new and is being used actively for 3 monthes maximum.
My hands like to get wet but not so hard, seems like normal.
But my edge pro got a little rust in the holes where the strings' ball ends go and a little rust on the little black pieces (don't remember the name of the part) that block the string on the bridge.

What can cause this? I assume my hand's sweat, but i'm not sure.
Are these bridges tend to get rusty? Should i think about swapping it with something else?
What would be the best choice to change the Edge Pro without rerouting?
Which brand or bridge to buy to get away from rust and to be the best fit for an Edge Pro equipped guitar?
 

·
Banned
Joined
·
9,291 Posts
Anything made of metal can eventually rust. Make sure to properly clean your trem every few months to avoid this. Or, you could buy one of the new carbon fiber Edge trems coming out......................................just kidding!
Use some WD-40 or bore oil to clean the trem and all pieces. A little oil goes a long way...
 
1 - 2 of 2 Posts
Top