Ibanez JEM Forum banner
5K views 3 replies 2 participants last post by  j.arledge 
#1 ·
So I have an Ibanez ART100 i'm working on and I got the Zakk Wylde EMG set in them, but the only problem that I'm having is the wiring from the old switch. Not sure of which of the red/bare or white/bare set got into the bus or not. Plugged the guitar in and have sound coming out, but neither of the volume knobs are working. a step in the right direction would be grateful
 
#4 ·
i hate the quick connect system. I had one set that i installed and i ended up just cutting the quick connect terminals off and wiring them pickups in the "old" regular way. I recommend you do the same.



If i remember right the color codes on the active duncans and emgs are the same. You can also leave out the second 9 volt and wire it like regular, with the ground going to the input jack and your hot going to your pickup hot.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top