Ibanez JEM Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hi, guys!
I have installed a Fernandes 401 in my RG 550 and it seem to work as it should, BUT.... when I adjust the FGC pot to adjust the output of the sustainer driver in the neck position its the output of the EVO 2 in the bridge that is affected. Is this right??
I thought that the FGC pot was to raise the output of the sustainer driver to match the output of the bridge PU, not to LOWER the output of the bridge PU??
Hope I explained this good enough.
 
1 - 1 of 1 Posts
Top