Ibanez JEM Forum banner

I need help undoing tone pot removal

1K views 11 replies 3 participants last post by  scorson 
#1 · (Edited)
I have an '08 RG1570 that I want to get rid of and one of the mods I did to it early on was deleting the tone. I left a few centimeters of wire on it to give me a clue later on but I should have taken more pics or written things down. Looking at this DiMarzio diagram I'm a little confused, https://d2emr0qhzqfj88.cloudfront.net/s3fs-public/diagrams/RG1570mod4.pdf
If you look at the pic I uploaded, I'm wondering if the left most sloppy solder on the volume of 2 stranded wires wrapped together I did, not sure. Also I spliced a few wires together. I think I did this just to extend the reach as I moved the volume down to tone hole. Update: I unsoldered (1 and 2) from (5/6 and 9). Does (1 and 2) go to (3 and 4) and (5 and 6) go to (7 and 8)? If so, where does 9 go? Thanks for any help/confirmation. I've edited this post a lot as I've been tinkering..
Sleeve Art Creative arts Paint Painting
 
See less See more
1
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top