Ibanez JEM Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi there!

I was wondering if someone here could help me out, as I've managed to salvage some parts from an RG 620X and would like to put the electronics into my RG570.

I would like to remove the Tone knob and the Piezo jack from this RG 620 circuit and I'm a bit of a novice with electronics and was wondering how I'd go about doing that.

Is it as simple as cutting the tone knob and jack out of the circuit?

Any help would be much appreciated,

Cheers!
 

Attachments

·
Registered
Joined
·
2,647 Posts
Hi there!

I was wondering if someone here could help me out, as I've managed to salvage some parts from an RG 620X and would like to put the electronics into my RG570.

I would like to remove the Tone knob and the Piezo jack from this RG 620 circuit and I'm a bit of a novice with electronics and was wondering how I'd go about doing that.

Is it as simple as cutting the tone knob and jack out of the circuit?

Any help would be much appreciated,

Cheers!
for the tone knob, it is in fact as simple as just cutting it out.

what is the goal for the peizo? to have it so you can operate in all three settings and have them come out one jack?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
for the tone knob, it is in fact as simple as just cutting it out.

what is the goal for the peizo? to have it so you can operate in all three settings and have them come out one jack?
That would be correct, yes! Thank you for your reply.

I'd like to be able to control the volume for both the Magnetic Pups and the Piezo, using the Mixed Signal output jack.

I'll have a stab at it today and break out the soldering iron, see how I manage.

Cheers!
 
1 - 3 of 3 Posts
Top