Ibanez JEM Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
648 Posts
It's a little tilted forward. You'll need to slightly tighten the trem claw screws in the back of the guitar and retune, loosening the strings a bit.
 

·
Premium Member
Joined
·
138 Posts
The springs are a little slacker than I'd usually set, so it's sitting a bit forward. One way to check is to take the backplate off and see if the block is sitting square inside the route.

Obligatory link to Rich's tech page... IBANEZ RULES!! tech - setup

Link to the Edge Zero II wiki page with setup instructions at the bottom... https://ibanez.fandom.com/wiki/Edge_Zero_II

(Although I must admit the trem in the instructions on page 2 looks suspiciously like an original Edge)
 

·
Registered
Joined
·
245 Posts
Big problem with this video is that he glosses right past unlocking the studs and doing height adjustments with the strings loosened.

Some disagree, but I don't. Loosen the strings and loosen the stud locks before adjusting bridge height. :smile:
 
1 - 6 of 6 Posts
Top