Ibanez JEM Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
My son offered to re wire a RG-120 completely.
we have the inf3 & inf4 with 4 wires - red, white, black, BLUE,
and of course the braided ground.
These will connect to a 3-way switch with 1 volume & 1 tone.
I have replaced the vol & tone with 500 pots and a 223 capacitor.
I cant seem to get the inf3 (neck) to work.
the 8 terminals on the switch look like this:
* *-* *-* *-* *
if this makes sense to you, the (-) represents the 2 terminals are bridged together.
I have had no luck with wiring diagrams found so far, (including looking at my 570 wiring).

any help would be greatly appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top