Ibanez JEM Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
I recently picked up a lefty RG2570 and soon I'll be replacing the pickups. I've decided to save a little and install them myself this time so I've been looking at the wiring and i'm not sure if im wired up right..probs just me being a muppet though. Here's a photo...



From the RG2570 wiring page (http://www.ibanez.com/wiring/wire.asp?y=2004&w=RG2570EX)

The red wire of the bridge should go into the first connector on the switch and the neck should go to the 3rd. On my guitar it seems to be the other way around. Same story with the black/white wires. Is this anything to do with it being a lefty, or does it not matter where you attach them?

Also, both my green wires go into the selector switch rather than to the volume pot, why is this?

Excuse my newbieness but this really is my first go at the world of electronics! Thanks.
 

· Registered
Joined
·
21 Posts
Discussion Starter · #4 ·
Great. So when I get my new pickups I should just copy this setup exactly?

I remember a few years ago I had some pickups put in a les paul copy I had and the selector switch was reversed so the guy must have put them in wired for a righty I guess!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top