Ibanez JEM Forum banner
1 - 3 of 3 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Hi guys, anyone replaced an edge pro with the original edge?
My question, do they both have same measurements and fit in the Ibanez JS tremolo routing?
I appreciate your feedback.

· Premium Member
3,390 Posts
I have a body that I did this to.
The two bottom corners of the trem cavity just needed to be squared up a bit.
I just used a paint stir stick wrapped in sandpaper.
It took a little while but I didn't damage the paint on top of the body at all.
Then I took some fingernail paint and covered the raw wood up to match the body again.
It took about 30 minutes of sanding.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.