[wildchild247]

Hello

I have no idea how to re wire,

Basically I want to replace all my electronics for new ones,

Firstly my guitar is a Jackson RR, it has a volume, tone and 3 way switch, it has two humbucker pickups.

Secondly where can I buy replacements,

Third how the hell do you re wire them up?

The reason I am replacing all this is because that the ones on there are crap and give me this hissing sound when I try to turn the volume knob up and down slowly.

Impossible for doing that violin sound, tremolo?? is it called.

Cheers

 

[Shep]

you most likely need to just replace the the volume pot..you can get parts from your local music shop...but i think you should just take it in and get a tech to do it all for you...i shouldn't cost to much.

 

[ryanb]

... or clean the pots ... or a bad ground or cold solder joint. You should be able to fix that without changing all of the electronics. Have a tech check it out.

 

[wildchild247]

... or clean the pots ... or a bad ground or cold solder joint. You should be able to fix that without changing all of the electronics. Have a tech check it out.

Ok I am a novice so I dont know how to solder or clean the pots.

Cheers

 

[TexicanHippy]

Hey dude, Ibanez puts the schematics on their website. I pretty much used the schematic from a JEM555 to rewire my RG350. I used allparts 'pots', my local shop carries alot of stuff so I was good

For some reason my switch was wired opposite than it is for them JEM5

hope I helped!

- Joe