Ibanez JEM Forum banner

Replacing a Lo-Pro Edge with a Floyd Rose using the old studs and inserts

1796 Views 0 Replies 1 Participant Last post by  pingfloid
I have replaced a Lo-Pro Edge with a Floyd Rose on a RG550LTD. I didn't have a big nut to use the trick to remove the stud inert (hardware shops are closed in Bangkok) so I have used the old studs.

The studs are a little bit different (I forgot to take a side-by-side picture) but so far it seems to work OK. Stable and fluttering.

Do you think that the edges could be damaged when using with different studs?

BTW: I do not have any complain about the Lo-Pro Edge. This is the fourth time I replace it on this guitar, due to heavy use, and I have chosen the Lo Pro Edge only because one guy was selling it for a good price

THe advantage of teh FLoyd Rose is am not going to deal again with the damn arm bushes. I like the arm to stay firm where I want

See less See more
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.