Ibanez JEM Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter · #1 · (Edited)
I have an RGIXL7 and it had bareknuckle pickups installed, but the coil tap was not hooked up so the green and white for each pup are not soldered, but upon looking in the cavity it is one of the new switches that has the solder pads and the plug that goes to the mini toggle, instead of the normal lugs, and I'm not sure what goes where. Does anyone have any resources that could help me? It's a 3 way blade with a DPDT mini toggle on-on for coil tap.

item is 3SWLHH3-CK , looks like this

Passive circuit component Circuit component Hardware programmer Electronic engineering Electronic component
 
1 - 1 of 1 Posts
Top