Ibanez JEM Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,459 Posts
Depending on how tight it is, you can put the stud in it and pull up CAREFULLY with a pry bar or claw hammer. Pull only straight up, and be very careful not to damage the threads, stud, or body finish. Put glue in the hole and press the anchor all the way down in. Something like epoxy will work well (some would say wood glue, but that won't hold to the metal very well). Make sure you don't get glue down in the threads inside the anchor. Another way to do it would be to just press the anchor back down in and then run some water-thin super glue down around the anchor, repeating until the gap around it is filled and the anchor is set firmly. Again, be careful to keep the glue out of the inside of the anchor.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top