Ibanez JEM Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
Asking people who may know.

I'm gonna switch back to valve pre/power but in a rack. It'll be an ENGL e570 into an ENGL 840/50. Pretty simple.

The bit I'm not clear about is - I want to use an axe fx 2 as a boost / effects unit only. Where do I put it in the chain?

  • Before the e570 and just push the axe output to the input of the pre?
  • In the effects loop of the e570?
  • After the e570 output sat between the pre and power phase?

In the effects loop seems the most sensible. Has anyone done this?
 

·
Registered
Joined
·
339 Posts
Discussion Starter · #3 ·
That is actually a method I hadn't considered.
So basically you ran guitar into pre amp, pre out into axe fx loop and then out to power amp? Hmmm.
 
1 - 3 of 3 Posts
Top