Ibanez JEM Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi, do anyone have a suggestion, how to wire just one humbucker with a
standard 5-way switch on a RG570, to get the most variations,
series, parallel, in/out of phase, singlecoil, direct to output etc.

thanks Søren
 

·
Registered
Joined
·
1,923 Posts
If you wanted all those combinations, you'd probably need to get a megaswitch of some sort. Mind you there ARE some interesting combinations you can get off a single humbucker, but without a megaswitch, your options are limited.
 

·
Registered
Joined
·
1,923 Posts
Actually the most useful combination that I've found on a one humbucker wiring is a 3-way switch wired so that you have:

outer coil - Humbucker(in series) - inner coil

A push-pull switch can be added to switch between series parallel wiring options. I actually did this to an RG321 that I installed a mini amp into the Neck Pickup cavity(ESP/Edwards Speak Up) and it only had 1 humbucker in the bridge. Pretty F'n cool cause I managed to turn a RG321 into a travel guitar(Am tempted to try this on an H-S-H guitar)
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top