Ibanez JEM Forum banner
Not open for further replies.
1 - 4 of 4 Posts

· Registered
1,917 Posts
Discussion Starter · #1 ·
Item for sale: Tech 21 Trademark 300 amplifier head w/rackmount kit & ARMD MIDI controller

Description & Condition:
Taken from Tech 21's site(www.tech21nyc.com/tm300.html).

Step up to the biggest and the baddest. Packing 300 watts of unfaltering SansAmp tone dare ye look directly into the eyes of the omnipotent Trademark 300 stack? Endowed with three fully independent channels in a traditional head format, our flagship model amplifier allows seamless switching between three of your favorite tones, from crystal clean to brutal crunch to searing lead. The active three-band EQ on each channel allows limitless tonal variations, putting you firmly in control of this beast. Available with a variety of cabinet options, the Trademark 300 is total tonal freedom with an arena-sized attitude.
-300 Watts RMS, 4-Ohm minimum load.
-Three independent Character switchable pre-amps.
-Boost function for solos increases the post gain volume level up to 9dB without altering your tone.
-SansAmp XLR Direct Out for stage and studio applications allows you to go direct to any mixing console.
-Effect Loop 1 (series).
-Effect Loop 2 (parallel) with Mix control to maintain signal integrity.
-Buffered Tuner Output for a tuner-friendly signal that also provides a clean dry output capable of driving a second amp head.
-Parallel speaker outputs should you want to use more than one cabinet.
-High quality, high efficiency, low noise toroidal transformer.
-Thermal and short-circuit protected outputs.
Amp is in like new, mint+, condition. It's never been gigged, never even left my house in the 2 years I've owned it. The optional rackmount kit has been installed, but I removed the front handles to re-install it into it's headshell. All that's needed to rackmount the amp is to remove it again, the 'ears' are still on it.

-Amp head in original box
-User's Manual
-Power and switch cords
-Extra parts to the rackmount kit
-ARMD MIDI converter, which allows all the amp's features to be controlled with a MIDI footswitch.

Asking Price: $500 Shipped in the USA. Will accept Paypal, Money Order, or Cashier's Check.

My Location: Daytona Beach, FL


(will add photo of footswicth soon)

Reason for selling: This is a great amp, but I no longer have any real intentions of gigging, and it's just too much amp at the current time.

· Registered
1,917 Posts
Discussion Starter · #2 ·
More photos:

Total package:


ARMD Converter:

This amp is Made in the USA, for anyone interested. I'm going to leave it up here a week or so, then it's off to auction.
1 - 4 of 4 Posts
Not open for further replies.